Bissell POWERTRAK 2598 Serie Guia Del Usuario página 9

Maintaining the Brush & Belt
In steps 1 and 5, you will need a
Phillips-head screwdriver.
1
Unplug vacuum, turn over
and unscrew 5 Phillips-
head screws and remove
bottom cover.
4
Place belt back on motor gear. Pull belt over the
Brush Roll and place back in. Position the Brush Roll
end opposite of the belt to line up with tab. The
end closest to the belt will slide in the tab without
needing any rotation.
2
Grasp the rotating brush
at both ends and lift out.
3
Inspect Brush Roll by placing
it on its end and spinning.
It should spin freely, multiple
times by one flick. If it
doesn't, replace Brush Roll.
Inspect belt, replace if it
appears damaged.
5
Reattach bottom replacing
the 5 screws. Spin the
Brush Roll by hand one
revolution to self-center
the belt.
www.BISSELL.com
9