The Illuminator/Lock Button; Connecting The Mc-36 - Nikon MC-36 Manual De Instrucciones

Parts of the MC-36 (3/3)
The "TIMER ACTIVE," "SET," and "RELEASE" Indicators
If this fl ashes It means this; do this to turn it off
Timer active (page 13); press TIM-
TIMER ACTIVE
ER START/STOP button ( ).
Settings can be modifi ed (page
SET
8); press SET button ( ).
RELEASE Manual release active (page 15);
(TIMER release shutter-release button
ACTIVE not ( ; if button is in HOLD position,
fl ashing) release shutter-release lock).

The Illuminator/Lock Button

The Illuminator/Lock Button
Press the illuminator/lock button ( ) briefl y to
activate the control panel backlight. The back-
light will remain lit for about six seconds; press-
ing the arrow button ( ) while the backlight is
on extends the timer for another six seconds.
To lock all controls except the shutter-re-
lease ( ) and illuminator/lock buttons, press
the illuminator lock button until the lock icon
( ) is displayed in the control panel. To release
the lock, press the illuminator/lock button until
the lock icon is no longer displayed.

Connecting the MC-36

1 Turn the camera off .
2 Check that the "TIMER ACTIVE" ( ) and "RE-
LEASE" ( ) indicators are not displayed.
3 Remove the 10-pin terminal cover from the
camera. Keeping the mark on the 10-pin
connector ( ) aligned with the mark on the
camera body, insert the connector as shown
and then tighten the locking nut.
Disconnecting the MC-36
After checking that the "TIMER ACTIVE" ( ) and "RE-
LEASE" ( ) indicators are not displayed, turn the
camera off and disconnect the MC-36. Replace
the 10-pin terminal cover.
En
7