Wagan Tech 2450 Manual De Usuario página 7

8. Turn the locking thumb lever to up position and remove stem
connector from valve stem. Also remove the valve stem adapter.
9. Store the compressor hose in its storage compartment.
Using the Jumper
IMPORTANT: Before attempting to start vehicle, this unit must be removed
from the vehicle's 12 V socket.
1. Turn off all lights and all other accessories (radio, etc) in the vehicle.
Tip: keep one small vehicle light or dial turned on to aid in determining
if the battery is charging.
2. Make sure the vehicle's 12 V Socket is clean and free of debris.
3. Put the lighted end of the male-to-male car power cord into the
vehicle's 12 V socket.
4. Put the end of the male-to-male 12 v car power card with no LED light
into unit's 12 V socket.
5. The indicator light on the 12 V connector will illuminate indicating
that the power is flowing. The light or dial left on in the vehicle should
brighten as well. Leave the unit connected to the vehicle's 12 V socket
for about 35 minutes.
6. If the light or dial does not brighten, turn the ignition key ONLY as
far as the accessory position (see vehicle owner's manual.) In some
vehicles, this is necessary for the 12 V socket to operate.
7. If the light or dial still does not brighten, turn off the light or dial, and
allow this unit to remain on the 12 V socket for at least 35 minutes.
Remove it from the 12 V and attempt to start the vehicle.
8. If the vehicle does not start, DO NOT attempt to start the engine more
that twice. Call a service center or tow truck.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2016 Wagan Corporation. All Rights Reserved.
6