Factory Settings; Mixer - Servo Motor - Control - meibes KE KELIT Thermix Información Técnica Para Montaje Y Funcionamiento

3. Factory settings

3.1 Mixer - servo motor - control

Factory settings of mixer / servo motor: Mixer open = no admixing on the flow side, position of toggle pin and groove according to dra-
wing, the manually operated handle, which is found on the motor, stands at 45° upwards.
see Fig. 6 and 6.1
Servo motor - technical data
Nominal voltage
Power consumption
Connection
Rotational direction
Manual operation
Torque
Rotation angle
Runtime
Acoustic power level
Position indicator
Assembly position
Protection class
Protection type
Ambient temperature
Storage temperature
EMV
Runtime
Maintenance
Weight
see Fig. 6.2, 6.3 and 6.4
15
Fig. 6 Position „open"
A Boiler B Closing segment of the mixer insert C Bypass pass (adjustable)
D Low temperature heating circuit
Fig. 6 Position „closed"
A Boiler B Closing segment of the mixer insert C Bypass pass (adjustable)
D Low temperature heating circuit
AC 230V 50/60 Hz
2.5 W
Cable 3 x 0.5 mm², length 2 m
selectable via wiring
temporary and permanent gear
latching with turning knob at
the housing
6 Nm (at nominal voltage)
electrically limited to 90°
140 s
max. 35 dB (A)
reversible scale plate 0 ... 1
user-defined except for hanging drive
II (protection insulated, without
IP 40
0°C ... +50°C
-30°C ... +80°C
CE
CE
maintenance-free
0.4 kg
Fig. 6.2 A
Manual operation
Fig. 6.3 A Automatic operated
Fig. 6.4 A 3 point regulator (Connection diagram)
E Flat portion at the shaft end parallel to the passage
E Flat portion at the shaft end parallel to the cross connection
3-level triggering
Application
The drive is used in connection with an assembly
kit as drive for the motorisation of the Meibes
mixers in the HKL system.
Mode of action
Triggering is effected by standard control systems
with 3-level output.
Product characteristics
Simple direct assembly with supplied adapter
kits suitable for all Meibes mixers. Position is
selectable in 90° steps.
Rotation angle is electrically limited to 90°.
With attainment of the end stops, the drive is
switched-off and therewith without current.
Manual operation
By means of a screwdriver, rotate the turning knob
into the „Manual operation" position (see detail 1).
Effiziente Energietechnik