Cassette Recorder; Playing A Cassette - Philips AZ 1007 Manual De Instrucciones

CASSETTE RECORDER

PLAYING A CASSETTE

1. Set the source selector to TAPE.
2. Press STOP•OPEN 9 / to open the cassette holder and
insert a recorded cassette.
3. Close the cassette holder.
4. Press PLAY 1 to start playback.
5. Adjust the sound using the VOLUME and DBB controls.
6. To interrupt playback press PAUSE ;. To resume, press the
button again.
7. By pressing 5 or 6,fast forwarding of the tape is possible in
both directions.To stop fast forwarding, press STOP•OPEN 9
/
8. To stop the tape, press STOP•OPEN 9 /
™ The buttons are automatically released at the end of the
tape, except if PAUSE ; has been activated.
9. With the source selector in TAPE/
is switched off when all the cassette buttons are released.
General information on cassette recording
• Recording is permissible insofar as copyright or other rights of
third parties are not infringed.
• This deck is not suitable for recording on CHROME (IEC II) or
METAL (IEC IV) type cassettes. For recording you should use
NORMAL type cassettes (IEC I) on which the tabs have not
been broken.
• The recording level is set automatically. Altering the VOLUME
and DBB controls will not affect the recording in progress.
• At the very beginning and end of the tape, no recording will
take place during the 7 seconds, when the leader tape passes
the recorder heads.
• To protect a tape from accidental erasure have the tape in
front of you and break out the left tab. Recording on this side
is no longer possible. To record over this side again, cover the
tabs with a piece of adhesive tape.
12
position, the set
POWER OFF
1