Troubleshooting - Philips AZ 1007 Manual De Instrucciones

If a fault occurs, first check the points listed below before taking the set for repair. If you are
unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no circumstances
should you try to repair the set yourself, as this would invalidate the guarantee.
PROBLEM
– POSSIBLE CAUSE
• REMEDY
No sound/power
– VOLUME is not adjusted.
• Adjust the VOLUME.
– Headphones are connected.
• Disconnect headphones.
– power cord not securely connected.
• Connect the AC power cord properly.
– Batteries exhausted.
• Insert fresh batteries.
– Batteries incorrectly inserted.
• Insert the batteries correctly.
Display does not function properly
– Electrostatic discharge.
• Switch off set, disconnect the mains plug and
reconnect after a few seconds.
CD playback does not work
– CD is badly scratched or dirty.
• Replace or clean the CD, see Maintenance.
– Laser lens steamed up.
• Wait until lens has acclimatized.
Environmental information Environmental information
All unnecessary packaging material has been omitted. We have done our utmost to make the All unnecessary packaging material has been omitted. We have done our utmost to make the
packaging easy to separate into three mono-materials: cardboard (box), expandable polystyrene packaging easy to separate into three mono-materials: cardboard (box), expandable polystyrene
(buffer), polyethylene (bags, protective foam). (buffer), polyethylene (bags, protective foam).
Your set consists of materials which can be recycled if disassembled by a specialized Your set consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment. materials, exhausted batteries and old equipment.
The type plate is located on the bottom of the set.

TROUBLESHOOTING

The CD skips tracks
– CD is damaged or dirty.
• Replace or clean the CD.
– SHUFFLE or PROGRAM is active.
• Quit SHUFFLE/PROGRAM mode(s).
Poor cassette sound quality
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see maintenance.
– Use of incompatible cassette types (METAL
or CHROME).
• Only use NORMAL (IEC I) for recording.
Recording does not work
– Cassette tab(s) may be broken out.
• Apply a piece of adhesive tape over the
missing tab space.
15