Final Installation - Litex Industries DTB54EP5CM Guia De Instalacion

WIRING (continued from previous page)
1C. If you intend to control the fan and light with separate wall
switches, wire as indicated in the instructions in 1A except
connect BLUE wire from fan to the BLACK supply from the
independent wall switch for the light and connect BLACK wire
from fan to the BLACK supply from the other independent wall
switch for the fan. [Fig. 1C]
Note: Black wire is hot power for fan. Blue wire is hot power for
light kit. White wire is common for fan and light kit. Green or bare
wire is ground.
2. Connect green wire from downrod (A) to green wire on
mounting bracket (C). [Fig. 2]
3. Strip 3/4 of an inch of insulation from ends of white wire.
Twist stripped ends of each strand of wire within the insulation
with pliers. [Fig. 3] Snip ends after twisting strands together.
Repeat for black, blue (if applicable) and green wires.
4. Screw wire connectors (O) on in a clockwise direction. Wrap
electrical tape around each wire connector (O) down to the wire as
shown in Fig. 4.
Warning: Make sure no bare wire or wire strands are
visible after making connections. Place green and white
connections on opposite side of box from the black and blue (if
applicable) connections.
Turn spliced/taped wires upward and gently push wires and wire
connectors (O) into outlet box.
FINAL INSTALLATION (continued on next page)
1. If necessary, partially loosen the two canopy mounting screws (Q),
on bottom of mounting bracket (C) that align with holes in canopy
(B). Lift canopy (B) to mounting bracket (C). Place rounded part of
the holes in canopy (B) over loosened canopy mounting screws (Q)
and push canopy (B) up. Twist canopy (B) to lock. Tighten both
canopy mounting screws (Q) securely. Slide canopy cover (X) up to
canopy (B), aligning rounded parts of slotted holes in canopy cover
(X) with screwheads in bottom of canopy (B). Turn canopy cover (X)
clockwise until it stops. [Fig. 1]
2. Install the 15 watt bulbs (I) provided with this fan into sockets in
motor housing (D). [Fig. 2]
Remove one screw from outer ring on underside of motor housing
(D) and partially loosen the other 2 screws. Slide glass housing (U)
over motor housing (D) until glass housing (U) touches top of motor
housing (D). Align slotted holes in motor housing plate (V) with
loosened screws on bottom of motor housing (D), and then twist
motor housing plate (V) to lock. Re-insert screw that was previously
removed. Secure motor housing plate (V) by tightening all three
screws. [Fig. 2] Be sure to tighten screws completely but be careful
not to overtighten screws as glass may crack or break.
FAN AND LIGHT CONTROLLED BY SEPARATE WALL SWITCHES.
Fig. 1C
SWITCHED FAN POWER
WHITE (NEUTRAL)
GROUND
GROUND
Fig. 2
Fig. 3
Fig. 4
top of motor
housing
I
5
WHITE
A
O
O
O
B
Q
X
Fig. 1
A
7
Fig. 2
SWITCHED
LIGHT
POWER
BLACK
BLUE
B
D
U
V