Motor Housing Bulb Replacement; Fan Operation - Litex Industries DTB54EP5CM Guia De Instalacion

FINAL INSTALLATION (continued from previous page)
9. Pull chain extensions (T) supplied in one of the hardware packs
or custom pull chain extensions (not included) may be attached to
fan and light pull chains. [Fig. 9]
NOTE: This fan is remote control adaptable (remote control not
included)

MOTOR HOUSING BULB REPLACEMENT

Important: Allow motor housing (D) and bulb(s) to cool down
before touching them.
When it becomes time to replace the bulbs (I) in the lighted motor
housing (D), locate access covers on the top of the motor housing
(D). Determine which access cover contains the burnt-out bulb (I).
Remove the access cover by removing the two screws at the edges
of the access cover--this will allow access to the burnt-out bulb (I).
Replace burnt-out bulb (I) with one candelabra base 15 watt max.
bulb. Repeat for each burnt-out bulb (I).

FAN OPERATION

1. The fan pull chain, labeled SPEED, has four positions. One pull is
HIGH, two pulls is MEDIUM, three is LOW and four turns the fan
OFF. [Fig. 1]
2. Pull the light pull chain, labeled LIGHT, to turn the light ON or
OFF. [Fig. 2]
3. Use the fan reverse switch, located on the switch housing (J), to
optimize your fan for seasonal performance. [Fig. 3]
Note: Wait for fan to stop before moving the reverse switch.
3A. In warmer weather, counterclockwise movement of the fan
will result in downward airflow creating a wind chill effect.
[Fig. 3A]
3B. In cooler weather, clockwise movement of the fan will
result in upward airflow that can help move stagnant, hot air
off the ceiling area. [Fig. 3B]
Access
Covers
D
7
D
T
T
Fig. 9
I
J
Fig. 1
J
Fig. 2
J
Fig. 3
Fig. 3B
Fig. 3A