Electrical Installation - Laguna PT1671 Guia De Funcionamiento Y De Mantenimiento

ELECTRICAL INSTALLATION

Place the appliance in a fixed position, in a dry and protected place with sufficient
ventilation around it.
• Protect the appliance from direct sunlight.
• Be sure that there is enough room around the unit for maintenance operations.
• To avoid overheating, do not cover the appliance.
MAINTENANCE
WARNING
Always stop the water supply and unplug or
disconnect all appliances in the pond from the electrical supply while the equipment
is being installed, repaired, maintained or handled. Never yank the cord and never
lift the appliance by the cable.
It is recommended that you:
• Make sure that internal parts of the appliance are dry before, during and after
the maintenance operations.
• Check that all the components are present and have been reassembled in
the correct way; if in doubt consult your local dealer for a replacement of the
defective component.
• Check that there are no leaks inside the appliance before connecting it to the
electrical supply after maintenance.
UV STERILIZER/CLARIFIER
INSTALLATION
WARNING
Do not install the UV Sterilizer/Clarifier
in the pond. Do Not Immerse in Water.
Check that the installation is done correctly before plugging in the appliance.
• The cord should be protected from abrasion, cuts and any other damage.
• Do not use the UV Sterilizer/Clarifier for any other purpose than that which it is
intended.
• Do not use this appliance in swimming pools or other situations where people
are immersed.
CONNECTING THE HOSING
The UV Sterilizer/Clarifier comes with two Universal Click-Fit couplings which allow
hosing connections of 3/4", 1" or 1–1/4" (19, 25, 32 mm) in diameter. Simply
cut the couplings at the appropriate increment using a small hack saw and attach
the proper hosing. If you wish to connect 1–1 / 2" (38 mm) hosing, use a Laguna
1–1 / 2" (38 mm) hosing connector which is sold separately (PT638). Attach one
end of the hosing to one coupling then click it onto the UV Sterilizer/Clarifier. Do the
same with the other hosing. Note that either opening on the unit can be used as the
entry point for the water.
INSTALLING THE
UV STERILIZER/CLARIFIER
Depending on pond set up, the unit may be installed horizontally or vertically using
the mounting brackets supplied.
Mounting bracket and
click-fit positioning options
It is recommended that the appliance be secured by the mounting brackets on a
wooden board. The board can be laid on the ground or secured to a fence in either a
horizontal or vertical orientation.
3