GYS STARTRONIC HYBRID 950 Manual De Instrucciones página 11

Translation of the original instructions
OPERATING INSTRUCTIONS
Standard connection
1
Ensure that the vehicle battery terminals are clean, free of grease and corrosion.
2
Connect the clamps to the battery terminals. The booster lights up by itself.
Standard mode
1
2
3
4
Working cycle :
If the motor does not start on the first attempt, make a maximum of 3 start attempts
5
consecutively.
Plan an interval of 20 minutes between each session (1 session = 3 starts).
Bypass mode
If the supercapacitors do not recharge during a standard mode procedure,
Or
If there is no battery mounted on the engine to be started, connect as shown below:
STARTRONIC HYBRID 950
STARTRONIC detects a battery.
The digital display shows the voltage of the vehicle battery
Les supercondensateurs du booster se rechargent automatiquement.
L'affichage numérique indique leur pourcentage de charge
If the vehicle's battery is too low to recharge the Startronic's supercapa-
citors, the lithium backup battery automatically switches on to recharge
them.
When the charging of the supercapacitors comes to an end, the ignition signal
appears .
Wait until «FUL» appears on the display and the beep sounds and then start the
engine.
EN
.
.
11