WARNING: Do not select the operating
mode when the tool is running.
Inserting and Removing SDS Plus
Accessories (fi g. D)
Your rotary hammerdrill uses SDS Plus
(refer to the inset in fig. D for a cross-section of an
SDS Plus
®
bit shank).
• Clean and grease the SDS Plus
• Insert the SDS Plus
®
bit shank into the SDS Plus
tool holder (5).
• Push the bit down and turn it slightly until it fits
into the slots.
• Pull on the bit to check if it is properly locked.
The hammering function requires the bit to be
able to move axially several centimetres when
locked in the SDS Plus
®
tool holder.
•
To remove a bit, pull back the SDS Plus
holder locking sleeve (15) and pull out the bit.
Fitting the Side Handle (fi g. E)
The side handle (9) can be fitted to suit both
right-hand and left-hand users.
WARNING: Do not use the tool without
the side handle properly assembled.
• Loosen the side handle.
• For RH-users, slide the side handle clamp over
the collar behind the tool holder, handle at the
left.
• For LH-users, slide the side handle clamp over
the collar behind the tool holder, handle at the
right.
• Rotate the side handle to the desired position
and tighten the handle.
Setting the Drilling Depth (fi g. F)
• Insert the required drill bit.
• Slacken the side handle (9).
• Fit the depth adjustment rod (8) through the hole
in the side handle clamp.
• Adjust the drilling depth as shown.
• Tighten the side handle.
Forward/Reverse Slider (fi g. G)
• Push the forward/reverse slider (2) to the LH-side
for forward (RH) rotation. See arrows on tool.
• Push the forward/reverse slider (2) to the RH-side
for reverse (LH) rotation.
®
Replacing the SDS Plus
with the Keyless Chuck (fi g. H)
®
accessories
DCH364
• Turn the locking collar (6) into the unlocked
®
bit shank.
position and pull the SDS Plus
®
• Push the keyless chuck (16) onto the spindle and
turn the locking collar into the locked position.
• To replace the keyless chuck with the SDS Plus
tool holder, first remove the keyless chuck the
same way as the SDS Plus
removed. Then place the SDS Plus
the same way as the keyless chuck was placed.
®
tool
Replacing the Dust Cover (fi g. D)
The dust cover (7) prevents dust ingress into the
mechanism. Replace a worn dust cover immediately.
• Pull back the SDS Plus
sleeve (15) and pull the dust cover (7) off.
• Fit the new dust cover.
• Release the SDS Plus
OPERATION
Instructions for Use
• Always observe the safety instructions and
applicable regulations.
• Be aware of the location of pipework and wiring.
• Apply only a gentle pressure to the tool (approx.
5 kg). Excessive force does not speed up drilling
but decreases tool performance and may shorten
tool life.
• Do not drill or drive too deep to prevent damage
to the dust cover.
E N G L I S H
CAUTION: Always wait until the motor
has come to a complete standstill before
changing the direction of rotation.
®
Tool Holder
®
tool holder (5) off.
®
tool holder was
®
tool holder
CAUTION: Never use the keyless chuck
(16) in the hammerdrilling mode. Only the
SDS Plus
®
toolholder should be used for
hammerdrilling.
®
tool holder locking
®
tool holder locking sleeve.
WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack
before making any adjustments or
removing/installing attachments or
accessories. An accidental start-up can
cause injury.
WARNING:
®
43