Important - Krups Beertender VB2158 Manual Del Usuario

Ocultar thumbs Ver también para Beertender VB2158:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
CHILLING THE DRAUGHTKEG
1. Before pouring a draught beer, it is very important that the Heineken
Heineken Premium Light
DraughtKeg™ reach the correct temperature.
2. Ensure DraughtKeg
Insufficiently chilled DraughtKegs
to purchase the DraughtKeg
intended use.
If the DraughtKeg
options:
a. Inside the BeerTender
it will take up to 18 hours to chill to the ideal serving temperature.
b. In a refrigerator – Depending on the temperature of your refrigerator, it will
take up to 12 hours to chill to the ideal serving temperature.
Tip: We recommend that you always keep an extra DraughtKeg
refrigerator to always have a chilled keg available.
PREPARING THE BEERTENDER

ImPOrTANT:

on before inserting the DraughtKeg
After setting up the BeerTender
n
detachable pour spout – this is the only part of the appliance that will
come into contact with the beer. The spout should be rinsed by hand. After
cleaning, screw back into place - fig. 5.
Before inserting the DraughtKeg
n
the patented disposable draught beer tube (5 tubes included) onto the
DraughtKeg
Open the BeerTender
n
the machine and remove the tap spout cover - fig. 7-8-9.
Place DraughtKeg
n
Position the draught beer tube as shown in drawing - fig. 11-12.
n
Put the tap spout cover back into place - fig. 13.
n
Carefully close the lid - fig. 14.
n
Set the drip tray and grate in place at the front of the appliance. Make sure
n
the drip tray is properly fitted and positioned.
wArNING!
not jut out from the surface it is resting on.
6
otice_krups_beertender_nafta.indd 6
DraughtKeg
®
is sufficiently chilled before pouring a draught beer.
TM
pre-chilled or pre-chill over night before
TM
needs additional chilling, there are 2 recommended
TM
– Depending on the temperature of the DraughtKeg
®
It is important that the BeerTender
®
- fig. 6.
TM
cover by pressing in the release panel on the top of
®
into BeerTender
TM
The drip tray must be positioned on a level surface and must
TM
and Newcastle Brown Ale
TM
will produce too much foam. It is ideal
TM
®
power switch is turned
®
.
TM
and before use, it is vital to clean the
into the BeerTender
TM
- fig. 10.
®
,
®
®
,
TM
in your
TM
, simply snap
®
10/08/10 11:49:11

Publicidad

Tabla de contenido
loading

Tabla de contenido