VONROC VC504AC Traducción Del Manual Original página 10

EN
6. Connect the mains plug.
7. Press the power switch (1) into the " ON/l" posi-
tion to start your vacuum cleaner.
8. The machine is now ready for blowing dust and
debris.
9. Press the power switch (1) into the " OFF/0" posi-
tion to switch off your vacuum cleaner.
Finish operation (Fig. A)
1. Turn off (1) the machine and disconnect the
mains plug.
2. Opening the drainage outlet (12) to allow the
vacuumed liquid to drain out.
3. Close the drain outlet (12).
4. Remove the top section (6) and empty the con-
tainer (8).
5. Clean the machine with a soft cloth.
6. Stow away the mains cable and accessory at
the machine. Store the appliance in a dry room.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that
the ventilation openings are free of dust and dirt.
Remove very persistent dirt using a soft cloth mois-
tened with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
Container
Empty the container (8) immediately after suction
cleaning because it is not designed to store liquids.
1. Opening the drainage outlet (12) to allow the
vacuumed liquid to drain out.
2. Close the drain outlet (12).
3. Remove the top section (6) and empty the con-
tainer (8).
4. Clean the machine with a soft cloth.
Filter cleaning system (Fig. A, G)
When the suction is getting weaker, please remove
the tubes (20) and jam the handle (19) by hand
(while the vacuum cleaner is working). Then press
the filter cleaning button (5) 10 times. This will
clean the filter (27) and recover the suction force.
10
Filters (Fig. A)
For optimal performance it is recommended
to regularly change the filters (17,18)
depending on level of use.
1. Carefully remove HEPA (17) or foam (18) filter.
2. Use a mild soap and water solution to clean the
filter and afterwards rinse with clean water.
3. Allow filter to air dry before installing and using
again.
4. Re-install the filter.
Float and filter cage (Fig. H)
Clean the float (30) and filter cage (31) regularly
with a soft cloth, and check it for damage. Other-
wise, its function can be impaired.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
WWW.VONROC.COM