Adjusting Suction Power - Philips FC9151/01 Manual De Instrucciones

English
8
triactive nozzle
The TriActive nozzle is a multi-purpose nozzle for carpets and hard floors.
- The side brushes catch more dust and dirt at the sides of the nozzle and allow you to clean
better along furniture and other obstacles (Fig. 9).
- The opening at the front of the nozzle allows you to vacuum larger particles (Fig. 10).
1 To clean hard floors, push the rocker switch on top of the nozzle with your foot (Fig. 11).
The brush strip for cleaning hard floors comes out of the housing. At the same time, the
,
wheel is lifted to prevent scratching and to increase manoeuvrability.
2 To clean carpets, push the rocker switch again (Fig. 12).
The brush strip disappears into the nozzle housing and the wheel is lowered automatically.
,
accessories
1 You can connect the crevice tool (1), the small nozzle (2) or the small brush (3) to the tube
or directly to the handgrip of the hose (Fig. 13).
- Use the crevice tool to clean narrow corners or hard-to-reach places.
- Use the small nozzle to clean small areas, e.g. the seats of chairs and sofas.
- Use the small brush nozzle to clean computers, bookshelves etc.
accessory holder
1 Snap the accessory holder onto the handgrip (Fig. 14).
2 Snap two accessories into the accessory holder:
- Crevice tool and small nozzle (Fig. 15).
Note: The small nozzle must be placed in the accessory holder as shown in the picture.
- Crevice tool and small brush (Fig. 16).
using the appliance
1 Pull the cord out of the appliance and put the mains plug in the wall socket.
2 Press the on/off button on top of the appliance with your foot to switch on the
appliance (Fig. 17).

adjusting suction power

During vacuuming, you can adjust the suction power.
- Use maximum suction power to vacuum very dirty carpets and hard floors.
- Use minimum suction power to vacuum curtains, table carpets, etc.
suction power knob
- During vacuum cleaning, you can adjust the suction power with the suction power knob on top
of the appliance (Fig. 18)
pausing during use
1 If you want to pause for a moment, insert the ridge on the nozzle into the parking slot to
park the tube in a convenient position (Fig. 19).
storage
1 Slide the tube parts into each other to reduce the tube to its shortest length.
2 Switch off the appliance and remove the mains plug from the wall socket.
3 Press the cord rewind button to rewind the mains cord (Fig. 20).