Honeywell Home HM700AFVALVE Instrucciones De Instalación

HM700AFVALVE
ELECTRODE STEAM HUMIDIFIER
FILL VALVE REPLACEMENT
CAUTION
Before Servicing
1. Disconnect main power source before
accessing internal compartments.
2. The plumbing and electrical compartments
contain high voltage components and
wiring. Access should be limited to licensed
HVAC professionals only.
3. During and following operation of the
humidifier, the steam components in
contact with the steam such as the cylinder,
steam lines, steam distributors, and
condensate lines can become hot and burn
if touched.
4. Humidity equipment installed by
unqualified personnel or the use of parts
and components not supplied with the
humidifier or this kit will void warranty.
Included in the Box
• Fill Valve
• Tie Wrap
• Clip
• Phillips Head Screws
• Installation Instructions
Tools Needed
• Screwdriver
• Pliers
Step 1
Refer to the humidifier operating manual if necessary.
1. Shut off water supply to the unit.
2. Disconnect power to unit.
3. Locate Fill Valve.
4. If necessary, remove cylinder.
Step 2
Removing old Fill Valve
1. Disconnect the wiring to the solenoid.
2. Using pliers, slide the spring clamp up the hose.
3. Disconnect the hose from the fill valve.
INSTALLATION INSTRUCTIONS
CAUTION
The remaining water located in the hose will
spill out.
Have something on hand to absorb the water.
VALVE HOSE
SPRING CLAMP
Fig. 1. Disconnecting old fill valve.
Step 3
1. On the opposite side of the wall where the valve
is mounted, unscrew the fitting from the fill
valve, and remove screws.
REMOVE
SCREWS
Fig. 2. Removing old fill valve.
WIRE
TERMINALS
M35701
REMOVE
FITTING
M35702
33-00158EFS-03