Publicidad
May we congratulate you on your new greenhouse
GB
DEAR CUSTOMER
Dear Customer!
Congratulations on purchasing your new
The assembly of your new house requires
greenhouse. It is important that you follow these
a bit of technical knowledge. However, it is
assembly instructions step-by-step.
important that the assembly instructions are
followed strict-ly. The assembly instruction
The assembly instructions are a combination of text
is a combination of text and illustrations. The
and illustrations. The profiles are packed in separate,
profiles are packed in separate numbered packs
numbered packs corresponding to their order of use
in the instructions. Assemble one pack at a time.
corresponding to the order in the assembly
All nuts, bolts and fittings are contained in bag No.
instruction. Erect one pack at a time. All nuts
0 (specified on page 12). Each pack is specified in
and bolts and fittings are found in bag No. 0
separate lists of components.
(specified on page 12). Each pack is specified in
All detailed illustrations are marked with the
separate lists of components.
following symbols:
All detailed illustrations are marked with
symbols:
Seen from the inside
Seen from the outside
Seen from inside
Seen from outside.
SOME SAFETY PRECAUTIONS
Assembly must only be carried out in dry and
•
calm weather.
Precautions.
Always wear work gloves when installing the
•
•
Assembly must only be carried out in dry
glazing. Greenhouse glass has sharp edges,
and calm weather.
especially if it breaks.
•
Always use working gloves while glazing.
Assistants and especially children must be
•
Greenhouse glass has sharp edges,
warned that broken glass is dangerous. Pick
especially if the glass breaks.
up all broken glass at once and remove it with
care.
•
Assistants and especially children must be
We recommend that you wear protective
warned that broken glass is an element of
•
glasses while fixing the spring wire clips.
danger. Pick up broken glass at once and
Any ladders that are used must be placed on a
•
remove it with care.
level surface.
•
We recommend to use protective glasses
It is essential to have an assistant available.
•
while fixing the spring wire clips.
•
Place the ladder on a level support.
PAGE 12: TOOLS
•
It is essential to have an assistant.
Assembling the greenhouse requires the tools
shown on page 12.
References
PAGE 15: FOUNDATIONS
The column marked
indicates the
No base is included with this product. However, an
page(s) on which the component is used.
original base is available separately. This base is easy
to construct and will guarantee you a stable base for
Page 13:
your greenhouse.
Foundation
If you construct your own base, the specified
The base is not included in this delivery.
measurements must be external measurements.
The holes must be dug out to below the frost line
However, an original base can be bought
(800 mm). Place the assembled base with anchor
separately. It ensures you a stable and easy to
legs over the holes so the anchor legs fit into the
build base.
holes; it takes about 75 litres of concrete to fill up
If you make your own base the measurements
the holes.
indicated must be external measurements.
Make sure the base is completely level and square.
If you buy an original base you furthermore
To square the base, make sure the two diagonal
need about 75 litres of concrete and 6/8
measurements are identical.
The width of the front and back gables must also be
plastic-/concrete pipes of about 800 mm which
identical.
are placed in a non-freezing depth for the
fastening of the corner and middle anchors.
PAGE 16-33: ORDER OF ASSEMBLY
The base must be 100% level and square; the
Place the components as shown on the illustration
latter is ensured by checking that the two
and assemble in the order shown in the pictures. Do
diagonal measurements are equal.
not tighten the nuts fully until the entire sub-frame
has been assembled.
Tools
The mounting of the greenhouse requires the
PAGE 26-29: DOORS AND WINDOWS
For easier assembly, we recommend that you oil the
tools shown on page 12.
screws for the doors. The glass or polycarbonate for
the door(s) and windows must be fitted at the same
Page 14-27:
time as the profiles.
Place the components as shown on the
illustration and assemble in the order shown
PAGES 30-33: FITTING OF GLASS
in the pictures. Do not tighten the nuts
Important before assembly!
completely until the front gable construction
Make sure that the gables and sides are level
has been assembled.
and square and that door(s) and window(s) are
functioning perfectly.
The best order of assembly for the glass or
polycarbonate is as follows:
Page 13:
Windows - Roof - Doors - Gables - Sides
(Fastening to the base).
When constructing your own base you have
PAGE 30-33: GLASS INSTALLATION
to drill holes (7 mm) in the ground frame
Degrease the sheets and frames with spirit.
between all the vertical frames, the greenhouse
Start glazing, one pane at a time. Apply a 3mm
is then fastened to the base with screws (A).
silicone bead around the vertical frames as indicated
Using an original base the greenhouse is
(the dotted lines on the illustration). (A 3mm bead of
silicone is sufficient to ensure maximum adhesion).
fastened to each vertical bar as shown on
If you use more silicone than recommended, extra
drawing B/C.
tubes can be purchased.
Page 24-27:
If you accidentally break a pane, carefully pull the
For an easier assembly we recommend that you
broken glass outwards and loosen the silicone using
oil the screws for the doors.
a sharp craft knife.
Clean the profile completely before inserting a new
Fitting of glass/polycarbonate
pane of glass.
Important before glazing!
M-strips are fitted as shown on pages 34-35. Place
the upper part of the strip under the aluminium
Make sure that gables and sides are level and
profile along the full length of the sheet and then
square, and that door(s) and window(s) are
click the strip into position from above.
functioning perfectly.
Your greenhouse is now fully assembled. However,
Best order of assembly:
please note the following:
1) Windows – 2) Roof – 3) Doors – 4) Gables
– 5) Sides
MAINTENANCE
Grease the doors (hinges and locks).
•
Keep the gutters free from leaves, etc.
Page 30-33:
•
Adjust the windows as necessary.
•
Glazing (illustration 1 to 8)
Replace any broken glass.
•
Degrease the sheets and frames with spirit.
Clean the greenhouse with disinfectant before
•
Start glazing from below, one glass at a time.
and after the growing season.
Apply a 3 mm silicone line on the vertical
frames where indicated (dotted lines on
WINTER PROTECTION
the illustration). (A 3 mm line of silicone is
If you anticipate snow during the winter, we
recommend the following winter precautions:
sufficient to obtain maximum attachment). If
Support the apex of the roof in the middle.
you do use more than recommended, you can
•
Remove any deep snow from the roof.
•
buy extra tubes.
Take precautions to prevent snow falling from
•
a tree or roof, for example.
Spring wire clips and glassholders are to be
Remove the cylinders for the automatic
•
fitted as shown.
window openers, if fitted (optional extras).
X = Spring wire clips, > = Glassholders
Secure the door(s) and window(s) to prevent
•
wind damage to the greenhouse.
In case of broken glass carefully pull it
WATER AND CONDENSATION
outwards and loosen the silicone by means of a
Please note that your greenhouse is not like a
sharp craft knife.
conservatory, for example, and that you should
Clean the profile completely before inserting a
therefore be aware that the greenhouse may leak
new pane of glass.
during or after precipitation and that condensation
will occur on the inside of the greenhouse. Good
Page 34-37:
ventilation will help prevent condensation.
Mounting of polycarbonate
INSURANCE
The illustrations at the bottom of page 34/36
Please note that not all insurance companies cover
show where to mount the polycarbonate plates
greenhouses automatically. Please contact your
and lists. The type indication states the length
insurance company to ensure that your greenhouse
in mm. A possible adjustment is made by
is covered.
means of a fine-tooth saw.
NB! To avoid the formation of algae the
GUARANTEE
polycarbonate sheets must not come into
Juliana greenhouses are covered by a 12-year
contact with the ground. Rest them on a piece
guarantee, which covers the replacement or repair
of faulty parts. The guarantee does not cover
of cardboard.
polycarbonate, glass, transport, assembly, freight,
etc.
A-lists are mounted as shown on page 35/37.
Juliana greenhouses are covered by a two-year
Put the sheet into the bottom list, bend the
warranty on painted parts, where fitted. Note that
sheet slightly outwards and put it in the top list.
marks on the paint may occur due to suspension of
the profiles.
M-lists are mounted as shown on page 35/37.
The guarantee will be void if the greenhouse is not
assembled in accordance with these instructions.
Place the upper part of the list under the alu.
profile in the whole length of the sheet and
COMPLAINTS
hereafter click on the list from above.
All our greenhouses are built to the highest quality
standards. However, should you experience any
B
problems, please contact your dealer at once. When
Sealing of the polycarbonate sheets
describing the defect, please state the greenhouse
The sheets may be sealed against insects.
model, the component number and the quality
Close the top end off with alu-tape or silicone.
control number.
The bottom only with airstrip tape to let
condensation out (available at your local
Any suspension marks or shiny ends on painted
dealer).
Juliana profiles will not be visible after the
greenhouse has been assembled.
Now your greenhouse is completely assembled.
Congratulations on your new greenhouse, which we
However, please notice the following:
hope will bring you a lot of pleasure for many years
to come.
Maintenance
•
Grease doors (hinges and lock).
Yours sincerely,
•
Clean the gutter for leaves, etc.
•
Adjustment of windows.
Juliana Drivhuse A/S
•
Replacement of broken glass.
•
Clean the house with disinfectant before
and after the growing season.
Winter Protection
In areas with occurrence of snow we
recommend the following winter protection:
•
Support the roof ridge at the centre of the
house.
•
Remove greater snow loads from the roof.
•
Take precautions against snow falling
down from for instance a tree or a roof.
•
Dismount the cylinders for the automatic
window openers, if any (optional extras).
•
Secure door(s) and window(s) preventing
wind damage to the house.
Insurance
Please note that not all insurance companies
cover glasshouses automatically. Please
contact your insurance company to ensure an
insurance coverage.
Guarantee
Juliana grants a guarantee of 12 years which
covers replacement of faulty parts. The
guarantee does not cover polycarbonate, glass,
transport, assembly, freight etc.
Juliana grants a guarantee of 2 years on painted
parts, if any. Note that marks in the painting
may occur due to suspension of the profiles.
The guarantee is invalid if the greenhouse is
not assembled according to these instructions.
Complaints
All our greenhouses are built to high standards
of quality. However, should a complaint
occur please contact your dealer at once.
Remember to specify the defect by indicating
the greenhouse model and number of the
component and the quality control number.
USA
Publicidad
