Ariston CHAFFOTEAUX EBUS2 Manual De Instrucciones página 12

associating the wireless device
ROOM SENSOR
- Position the room sensor so that it is
close to the receiver.
- Check that the radio receiver is pow-
ered up (green led on).
- Power up the room sensor with its two
batteries (included in the kit).
- Hold the button on the receiver down
for 5 seconds; the red led will start
fl ashing.
- Hold the "+" key on the room sensor
down for 5 seconds (Fig. 5). The display
will alternate between the software ver-
sion and modifi cation index.
- Hold "+" down for 5 seconds again to
enter the technical parameters menu;
parameter "rF01" will display (Fig. 6).
- Press 'OK'.
The display will show the number of as-
sociated wireless devices.
- Hold "OK" down for 3 seconds to
launch the association procedure.
- Once the association procedure has
terminated, the display will show the
updated number of associated devic-
es. The receiver's red led will go out.
Check that the room sensor is listed
on the system interface in parameter
0.2.0.
(If the association procedure fails, the
red led on the receiver will stay on. In
this case, repeat the procedure as de-
scribed above.)
ATTENTION!
If the receiver's coverage is not suffi cient,
you must use an aerial.
Refer to the aerial's manual for its associ-
ation procedure.
12 - GB
Fig. 5
Fig. 6
x 5s
x 5s