Ariston CHAFFOTEAUX EBUS2 Manual De Instrucciones página 14

associating the wireless device
TWO-ZONE CONTROL MODULE
• Check that the connection between
the receiver and the heat genera-
tor has been completed successfully
(green led on) (Fig. 3).
• Check that the 2 zone module is pow-
ered up (green led on). (Fig. 9)
• Hold the button on the 2 zone module
down for 3 seconds; the red led will
start fl ashing.
• Press the 2 zone module button down
again to associate the zones to the out-
puts.
The red led will fl ash to indicate the as-
sociated zones:
1 fl ash every 2 seconds: zones 1 & 2
2 fl ashes every 2 seconds: zones 3 & 4
3 fl ashes every 2 seconds: zones 5 & 6
250ms
2s
• Once you have selected the zones,
press the receiver button until the red
led starts fl ashing slowly. The receiver
is now in association mode.
• Keep holding the button down; the red
led will start fl ashing quickly to indicate
that association with the module is in
progress.
• If the procedure has terminated suc-
cessfully, the red led on the 2 zone
module will go out.
NOTE: the red led on the receiver will go
out if a room or external sensor is associ-
ated, otherwise it will stay on.
14 - GB
MULTIZONE CONTROL MODULE
• Check that the multizone module is
• Check that the multizone module is
• Check that the receiver is connected
• Hold the button on the multizone radio
Zone 1&2
Zone 3&4
Zone 5&6
• Hold the receiver button down until
• Keep holding the button down; the red
• If the association procedure is suc-
Fig. 9 BUTTON
RED LED
powered up (green led on) (Fig. 10)
connected to the included radio mod-
ule
to the heat generator and power up
(green led on)
module down for 3 seconds; the red
led on the radio module and the 6 leds
on the multizone module will start fl ash-
ing
the red led starts fl ashing slowly. The
receiver is now in association mode
led will start fl ashing quickly to indicate
that association with the module is in
progress
cessful, the multizone radio module's
red led will go out and the multizone
module leds for the active outputs will
turn on
Fig. 10
LED
GREEN LED