Preparing The Remote Control - Polaroid DVC-2000 Manual Del Usuario

Remote Control

PREPARING THE REMOTE CONTROL

To operate the Combo Player, you must first place the batteries in the remote control.
1
Open the cover.
OPERATING WITH THE REMOTE CONTROL
Operating player with the remote control.
3 0 3 0
!
BATTERIES
INCORRECT USE OF BATTERIES MIGHT CAUSE THEM TO LEAK
• Do not place the batteries in the wrong direction.
• It is dangerous to charge, heat, open, or short-circuit the batteries.
• Do not leave dead batteries or mix new with old batteries in the remote control.
• When not using the remote control for a long duration of time, remove the batteries.When operating range becomes reduced,
replace batteries.
• If battery leakage occurs, wipe the battery liquid from the battery compartment, then replace batteries.
!
REMOTE CONTROL
• The remote control should be aimed directly towards the remote sensor of the Combo Player.
D V C - 2 0 0 0
Continued
2
Insert batteries (AAA size).
Make sure to match the + and - on
the batteries to the marks inside the
battery compartment.
The remote control must point at the remote sensor in order for the
remote to function correctly.
Distance: Maximum of 7 m from the front of the remote sensor.
Angle: Approximately 30º from each direction.
*Do not place the remote control under intense light source such as direct sunlight.
, .
CORRODE OR EXPLODE
3
Close the cover.
7