Using Ellison Surecut, Clearcrop Or Ellison Custom Dies; Helps & Hints - Ellison Big Shot Pro Sizzix Instrucciones

®
Using Ellison SureCut
Ellison SureCut and ClearCrop Dies can be used in the Sizzix Big Shot Pro Machine
without the Adapter Pad, as they are thicker than Sizzix Bigz Dies. Place SureCut
and ClearCrop dies directly on the metal Sliding Tray, rubber side facing up. Place
material to be cut against the rubber side of the die, then place one Cutting Pad on
top of the material (Figure I). For Ellison SureCut Crease-Rule Dies, place Premium
Crease Pad, instead of the Cutting Pad, on top of material to be cut. Follow Steps
3–5 in Operating Instructions, page 6.
5. Helps & Hints
• Dies perform better when they are placed rubber side up on the Sliding Tray.
• Dies perform better when they are used with appropriately sized cutting pads.
See Die and Accessory Compatibility Table on page 14.
• For easier cutting, place dies on Tray diagonally.
• Use the Big Shot Pro Machine to cut a variety of different materials.
See Materials Guide on page 13 for suggestions.
• Fewer sheets of material should be used when cutting very complicated shapes.
• When cutting felt, poly foam or delicate materials, place a scrap of paper over
the material to be cut.
• Use of Premium Crease Pad is required with Crease-Rule dies.
• Use only one sheet of material with Crease-Rule dies.
• If crease rule is cutting through the material rather than creasing the material,
place the die and material to be cut on the Adapter Pad diagonally (as size
allows) and then cut.
• It is important to use the Die Pick (included with the Big Shot Pro) to clean
out the bits of paper and other material that build up in the joints of the dies
(where the cutting rule meets). If dies are not kept clean, the scraps will
eventually push the rule slightly apart.
Figure I
™ ™
or ClearCrop
10
(or Premium Crease Pad)
Die
Dies
Cutting Pad
Paper