Operating Instructions; Using Bigz Pro, Bigz Xl, Bigz Or Originals With Crease Rule - Ellison Big Shot Pro Sizzix Instrucciones

4. Operating Instructions

See Die and Accessory Compatibilty Table on page 14
Sliding Tray
Using all Sizzix Bigz
Crease Rule*
1. Place a die on a Cutting Pad with foam side up. Place paper or desired material
to be cut on top of the die. Place the Premium Crease Pad on top of the paper
or material to create a "sandwich" (Figure B). (Extended Cutting Pad and
Extended Crease Pad [both sold separately] may also be used with XL-sized
dies.) A Mylar Shim may be necessary; see Troubleshooting Solutions on page 12.
2. Place sandwich on top of the Adapter Pad in the Sliding Tray.
3. Push Sliding Tray into the opening of the Big Shot Pro Machine. Keep hands
away from roller and dies while in use.
WARNING
4. Note the rotation of the Crank Handle and continue to rotate it in the same
direction until the sandwich has passed through the opening of the rollers.
Dies can be passed through the rollers in either direction, from the right or
from the left.
5. Remove the sandwich from the Big Shot Pro. Your die-cut shapes are ready
to use!
*A Crease-Rule Die is similar to a regular Bigz (steel rule) Die; however, it contains
both cutting (sharp) rule and crease (blunt) rule.
"Sandwich"
Adapter Pad
Figure B
™
Pro, Bigz XL, Bigz or Originals
Pinch and cutting hazard. Keep hands, fingers
and clothing away from contact with rollers
and dies while in use.
6
Premium Crease Pad
Paper
Die
Mylar Shim
Cutting Pad
™
Dies with