Using Textured Impressions Pro Embossing Folders; Using Texturz Texture Plates - Ellison Big Shot Pro Sizzix Instrucciones

Textured Impressions Pro
Embossing Folder
Using Textured Impressions
1. Open embossing folder and insert paper, cardstock or other embossable
material, making sure that the edge of the paper rests against the small
edge-blocks inside the die. Close the folder.
2. Place the closed Textured Impressions Pro Embossing Folder on top of the Big
Shot™ Pro Solo Platform (sold separately). DO NOT USE CUTTING PADS
(Figure G). Place on top of the Adapter Pad in the Sliding Tray.
3. Follow Steps 3–5 in Operating Instructions, page 6.
Sliding Tray
™
Using Texturz
1. Place a Texture Plate on the Big Shot Pro Solo Platform and Solo Shim
(sold separately) with the desired design facing up. Place paper or desired
material on top of the Texture Plate. Place Silicone Rubber on top of paper.
Place Impressions Pad on top of Silicone Rubber to create a "sandwich"
(Figure H).
2. Place sandwich on top of the Adapter Pad in the Sliding Tray.
3. Follow Steps 3–5 in Operating Instructions, page 6.
Paper
Figure G
™
Pro Embossing Folders
"Sandwich"
Adapter Pad
Figure H
Texture Plates
9
Textured Impressions Pro
Embossing Folder
Solo Platform
Impressions Pad
Silicone Rubber
Paper
Texture Plate
Solo Shim
Solo Platform