Programming Instructions; Reclining Tension Adjustment Instructions - LAZBOY La-Z-Touch Instrucciones De Operación

®
La-Z-Touch 10-Motor Massage & Heat Recliner

Programming Instructions:

The program feature provides the ability to program the intensity levels of the
vibrating massage motors in each zone.
To Use The Program Feature
1. Press PRGM to activate the feature (the light will start blinking).
2. Press ZONE 1, Upper Back, and set the intensity level desired.
• Press + intensity to increase the intensity level
• Press - intensity to decrease the intensity level
3. Press ZONE 2, Lower Back, and set the intensity level desired.
4. Press ZONE 3, Hip Region, and set the intensity level desired.
5. Press ZONE 4, Upper Thigh, and set the intensity level desired.
6. Press ZONE 5, Lower Thigh, and set the intensity level desired.
7. Press PRGM to use the set intensity program that you just selected, which can
be used with any ZONES selected and in any mode--PULSE, WAVE and CIRCLE
(the light will now remain steady).
8. Press PRGM again to deactivate the set intensity program mode and return
to the default settings (the light will go off).
Your program remains in memor y until you set a new program. To activate the
set program again
1. Press PRGM to activate the feature (the light will start blinking).
2. Press PRGM again to use the last programmed setting (the light will now
remain steady).
3. Press PRGM again to deactivate the feature and return to the default settings
(the light will turn off).
NOTE: The program may be reset to the default settings when a disruption in
the power supply occurs, such as an electrical power outage, and you will
need to reset the program to your desired settings.
18
Reclining Tension Adjustment
Instructions:
Customize the reclining action of your Reclina-Rocker
WARNING
-- Risk of injur y.
• This unit is equipped with a tension adjustment feature for the reclining
mechanism that is preset at the factory. The tension setting can be changed for
your personal preference. To avoid tipover and assure stability, do not operate
the unit with the tension adjustment wing nuts completely loosened (see
Adjustment Instructions).
NOTICE:
Risk of damage.
• Make sure the legrest on each unit is closed before tilting forward and
adjusting the tension.
• Do not completely tighten the wing nuts, as damage will occur. The tension
springs should not be completely compressed after making adjustments.
If this occurs, the wing nuts must be loosened counterclockwise a
minimum of 1 ⁄ -turn to avoid damage to the spring tension assembly.
2
• Do not completely loosen the wing nuts. The spring should not slide on the bolt
after making adjustments. If the spring slides on the bolt, tighten the wing nut
clockwise a minimum of 1 ⁄ -turn, after the spring no longer slides on the bolt.
2
• Adjust bot h wing nuts equally.

Reclining Tension Adjustment Instructions

You can adjust the tension of the reclining mechanism to respond to your
individual size.
1. Gently tilt the reclining chair forward to rest on its arms and top of the back.
Locate the wing nuts, one on each side, toward the back of the recliner
under each reclining seat (F
IGURE
2. Adjust the tension by turning the wing nuts in
setting is reached.
• A taller or heavier person may choose to increase the reclining tension
by tightening the wing nuts clockwise.
• A smaller person may choose to decrease the reclining tension by
loosening the wing nuts counterclockwise.
3. Return the reclining chair to the upright position. Test the new setting.
Make additional adjustments if needed following these steps.
F 1
IGURE
® ®
or Reclina-Way
1; only one side shown).
1 ⁄ -turn increments until the desired
4
Tension Spring
Wing Nut
Chair.
19