La-Z-Touch; 2-Motor Massage & Heat Recliner; Assembly Instructions - LAZBOY La-Z-Touch Instrucciones De Operación

®

La-Z-Touch

2-Motor Massage & Heat Recliner

Assembly Instructions:

WARNING
To reduce the risk of injur y:
• Do not operate the unit until the back is installed and locked.
NOTICE:
Do not plug the transformer in until instructed.
1. The power transformer is secured to the seat swing. Carefully cut the cable tie
and set the power transformer aside.
2. Install the back.
• Lay the back across the arms of the body (F
• Lift the back at a slight angle and align the brackets on the back with the
brackets on the body (F
IGURE
• Lower the back onto the body, making sure the back and body brackets
are completely engaged.
• Lock the brackets by using a screwdriver to push down the locking levers (F
3. Locate the massage connectors.
• Stand at the side of the chair and push the back rearward to recline
the seat and back.
• Gently tip the chair forward to rest on its arms and the top of the back,
revealing the underside of the chair and the connectors.
4. Identify the two connections you will make.
• Locate the three wires with connectors next to the body rear rail, toward the center.
• The two rectangular-shaped connectors are for the Hand Wand connection (F
• The round-shape connector is for the Power Transformer connection (F
5. Connect the Hand Wand.
• Align the two rectangular-shaped Hand Wand connectors (some of the
connector pins are square, others are round).
• Push the connectors together until they lock.
6. Connect the Power Transformer.
• Plug the Power Transformer connector into the connector located at
the center, bottom panel of the chair back. Make sure the connectors
are secured with no gaps between them.
7. Return the chair to its upright position.
• Hold the Power Transformer cord away from the base and gently tip the chair
back, until it is completely upright and setting on its base. Make sure the Power
Transformer cord is not pinched between the base and the floor. Return the
seat and back to the upright position.
8. Choose a location for the chair that is close to an electrical outlet and
proceed to the Operating Instructions.
NOTICE:
To prevent damage to the connectors and cords, it is important
to unfasten all connections prior to removing the back. Reverse the Assembly
Instruction steps when removing the back.
6
1).
IGURE
2).
IGURE
La-Z-Touch
F
IGURE
Power Transformer Connector
3).
IGURE
F
IGURE
1).
IGURE
1).
F
IGURE
®
2-Motor Massage & Heat Recliner
Assembly Details:
1
Hand Wand Connector
Hand Wand Connector
Power Transformer
2
Body
Bracket
Back
Bracket
( Figure shown without electrical connectors )
3
Back Bracket
Locking
Lever
Locked
Position
7