Publicidad
Step 3
1. Fasten the END MOLDINGS (G) to the TOPS (A2). Tighten
å
four HIDDEN CAMS.
2. Fasten a LEFT FRONT/RIGHT REAR MOLDING (J2) and a
å
RIGHT FRONT/LEFT REAR MOLDING (K2) to each TOP (A2)
and END MOLDING (G). Tighten twelve HIDDEN CAMS.
Follow the diagram closely.
The HIDDEN CAMS
should be here.
K2
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
www.sauder.com/services
G
1st
A2
Start
Arrow
J2
A2
J2
Maximum
210 degrees
Minimum
190 degrees
420374
K2
G
1st
The HIDDEN CAMS should
sit above the TOP (A2).
Tighten
Arrow
Page 7
Publicidad
