Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
VEHICLE FRAME
1/2" x 2 1/4" HEX BOLT
M12 X 45MM BOLT
1/4" X 1" X 1 1/2"
BOLT PLATE
EXISTING HOLES
DRILLED HOLE
HOLE 3
HOLE 1
SIDE PLATE ASSEMBLY
CENTER SECTION
NOTE:
General assembly - loosely assemble center section (page 1); loosely install side brackets on vehicle (this page);
install center section assembly; tighten all fasteners to proper specifications (page 1)
99-04 FORD F-250, F-350 SUPER DUTY PICKUP
1. Lower spare tire.
2. Place 1/2" x 2 1/4" bolts and 1/4" bolt plates in noted existing holes in frame. Both sides.
3. Aligning hole 3 and 4 in bracket with bolts in frame. Raise hitch side bracket, 3/8" bolt plate, 1/2" conical washer, and
1/2" nut into position, as shown, both sides. loosely install nuts.
4. Using hole 1 in bracket as a guide, drill a 1/2" hole in frame.
5. Install the M12 x 45mm hex bolt and 1/4" bolt plate though hole in frame. Install 1/2" conical washer and M12 nut, both
sides, finger tight.
6. Install center section as pre-assembled on front page with (4) 3/8" x 1 ¼" bolts and washer nuts, both sides. Align
center section of hitch with center of vehicle. Finger tighten fasteners.
7. Tighten hitch side bracket to frame. Tighten side plate assembly to side bracket. Tighten side bracket assembly to
center section.
8. Raise spare tire back into place.
INSTALLATION E
1/2" X 2 1/4" CARRIAGE BOLT
HOLE 4
3/8" WASHER NUTS
1/2" CONICAL WASHER
M12 NUT
1/4" x 1-1/2" x 3"
BOLT PLATE
3/8" x 1 1/4 bolt
3/8" x 1-1/4" x 2 1/2"
1/2" NUT
TOOLS REQUIRED
9/16", 3/4" SOCKET
1/2" DRILL BIT
18MM SOCKET
TORQUE WRENCH
SAFETY GLASSES
HITCH SIDE BRACKET
3/8" x 1-1/4" x 2 1/2"
BOLT PLATE
1/2" CONICAL WASHER
1/2" NUT
BOLT PLATE
8
Publicidad
Tabla de contenido
