Klarstein Clearcube LCD Manual Del Usuario página 22

EN
22
4. Ice-Full reminder
When the drop ice testing panel is pressed down by ice cubes, the ICE-FULL indicator
will light up and the machine enters into ice-full reminder mode. If the ice cubes are
removed and the drop ice testing panel is raised again, the machine will go to ice-
making mode automatically.
5. Water leakage reminder
As the water level drops, the float switch also lowers. When the float switch is in low
level, the add water indicator will blink. When the pump is drawing water and the float
switch is still in low level, the add water indicator will continue to blink. If the machine
has an automatically feed water function, the inlet valve will open automatically to add
water when the add water indicator blinking.
When the water leakage reminder appears, please add the appropriate volume of
water. Once the float switch leaves the low level, the machine will enter into ice-making
mode automatically.
6. Malfunction reminder
If the ice maker machine can't detect an ice drop signal for three times during ice
making process, it will show the fault icon and a buzzer sound will appear at the same
time. The machine goes into fault alert status. At this point, you need to check whether
there is ice or foreign bodies blocking the ice detection plate's turning off. To end the
fault mode, tap lightly from above on the ice detection plate (the plate directly below the
evaporator grid) until a slight click is heard.
7. Self-clean mode
In standby mode, keep pressing the On/Off button for 5 seconds, the ice making, ice
full and add water indicators are blinking simultaneously, the machine enters into self-
clean mode. Press the On/Off button for 5 seconds to exit self-clean mode.
8. De-icing mode
In ice making mode, pressing the ice making button and the SELECT button (for ice
cube size selection) simultaneously for 5 seconds will interrupt ice cube production and
remove the ice (already produced ice is ejected into the ice cube storage box). Pressing
both buttons simultaneously again for 5 seconds will exit this mode and return you to
standby mode. If you want to continue with ice cube production, press the ice making
button again.
9. Clock and time setting function
1. Real time setting: Press the SET button one time, „88" is blinking in the hour display.
Press the  button to set the hour. Press the SET button once again, „88" is blinking
in the minutes display. Press the  button to set the minutes.