KTM Power Parts 55135041044 Guia De Inicio Rapido página 4

4
3
8
9
5
6
10
4
4 3
8
13
9
30mm
1
2
7
A
11
B
12
9
C
50mm
3
14
D
Scope of delivery:
1x fan (1)
1x fan wiring harness (2)
1x thermoswitch (3)
1x aluminum seal ring (4)
1x fan bracket (5)
3x screws (6)
3x blind rivets (7)
1x plug-in fuse
1x connecting piece, assembled (8)
2x hose clamps (9)
Preparations
- Dismantle the seat and tank.
- Drain the coolant (see the owner's manual).
- Dismantle the right-hand radiator.
Assembly
- Mount the fan (1) on the fan bracket (5) using the screws (6).
Ensure that the cable (10) is positioned as shown in the figure (A).
- Mount the fan bracket and fan on the right-hand radiator using the blind
rivets (7) in the provided holes (11) (Figure B).
- Mount the right-hand radiator.
- Remove the hose system and thermostat (Figure C).
- Cut off 50mm of hose (12) (Figure C).
- Cut off 30 mm from the remaining hose (13) (Figure C).
- Mount the hose piece (13) on the connecting piece (8) using the hose clamp
(9) as shown in the figure.
- Screw the thermoswitch (3) with the aluminum seal ring (4) into the con-
necting piece (20Nm).
- Then mount the connecting piece with the thermoswitch and the moun-
ted hose piece (13) onto the hose piece (12) using the second hose clamp
(Figure C)
- Mount the assembled hose system back into the vehicle.
- Connect the fan wiring harness to the vacant connector of the main wiring
harness (Figure D).
NOTE:
Ensure that the cables are routed properly and without kinks. Secure the
wiring harness using cable binders.
- Connect the fan wiring harness to the thermoswitch (3) and fan.
- Fully mount the rubber sleeve (14).
Final steps
- Fill the cooling system (see the owner's manual).
- Check that the fan is functioning properly.
- Mount the seat and tank.
58435041000
59011079100
78035045000
0603142015
81235943000
0081500181
0011400800
58011109105
55135916044
10001020000