Extremis GARGANTUA Instrucciones De Montaje página 5

5. Firmly tighten all short bolts M10 with the nuts M10.
7. Turn the benches upside down and put them at the highest
level (table top level). Make sure all the benches form an equal
concentric circle and then tighten the bolts.
USE
° To change the height of a bench, grab the bench with both
hands and subsequently hook it in at the desired height between
the two tubes of the leg. Make sure the bench is securely fixed
and is hanging in a horizontal position. The slight movement
you feel as you are sitting down, is the play necessary to
remove the benches.
° The longer you use the benches, the tighter they will be fixed.
To remove them, you will need to grab the bench at the metal
frame and move it sideways a few times. This movement will
slightly loosen the bench making it easy to unhook it. Never
pull the wooden laths with full force.
6. Fix the bench hook to the bench by means of the M8 bolts and
the spring locks.
ATTENTION: don't tighten the bolts yet!
8. Turn the table around and hang the benches at the desired
height.
° The middle of the tabletop is equipped with an opening to
insert a parasol. If you do not use a parasol, the opening should
be covered with the stainless steel disk supplied together with
the table.
english 5