Assembly Back Rest; Assembly Floor Fastening - Extremis GARGANTUA Instrucciones De Montaje

ASSEMBLY BACK REST

WHAT YOU NEED
2 people
no. 17 spanner
+/- 5 min. (1 piece)
2. Hold the backrest so that the holes in
the flat parts are situated just below the
holes in the clips. Two people are
needed for this part of the assembly.

ASSEMBLY FLOOR FASTENING

WHAT YOU NEED
1 person
no. 13 spanner
+/- 15 min.
8 assembly back rest + assembly floor fastening + assembly inumbr(in)a
1. Insert the two clips (per back rest) between the third and the fourth plank, with its
opening pointing towards the floor.
3. Put the bolts through the hole in the
back rest and tighten then in the clips.
Insert the anchoring plate in the table leg groove on the inside of the table leg and fasten
it to the ground. Use the fixing media most suited to the type of ground on which you
intend to install the Gargantua table.
Repeat these operations for the other three table legs.
4. Firmly tighten the bolts using an open-
end spanner to prevent them from
loosening spontaneously. Repeat these
operations for every backrest.