Connections On The Back; Connecting The Monitor; Connect Signal Cable; Connect Audio Cable - Medion AKOYA P54016 Manual De Instrucciones

Connections on the back

Power supply (POWER IN)
1.
HDMI connection (HDMI)
2.
Mini 15-pin D-sub connection (VGA)
3.
3.5 mm stereo jack audio connection (AUDIO IN)
4.
Intake device for protection against theft (Kensington lock)
5.

Connecting the monitor

 Ensure that the TFT monitor has not yet been connected to the electricity supply (mains plug not yet
plugged in) and that neither the TFT monitor nor the computer has been switched on.
 Prepare your computer for the TFT monitor if necessary, so that the correct settings for it will be present.

1 Connect signal cable

 Plug the signal cable into the appropriate VGA or HDMI connections on the computer and the TFT monitor.

2 Connect audio cable

 Plug the audio cable into the appropriate audio sockets on the computer and the TFT monitor.

3 Connect the power supply

 Connect the power cable of the power pack to the TFT electricity supply connection.
Now, connect one end of the mains cable to the power pack and connect the other end to a suitable socket.
The mains socket must be in the vicinity of the TFT monitor and be easily accessible (use the same electricity
circuit as for the PC).

4 Switch on the monitor

 Switch your monitor on at the Standby/On switch on the front of the device.
Finally, switch your computer on.
(Ill.: Rear of the monitor)
Bringing the device into operation
9