Kohler K-2276 Guia De Instalacion página 9

Foam Gasket
(supplied
with the sink)
O-Ring
(supplied
with the sink)
4. Vessel Installation
CAUTION: Risk of personal injury. Handle with care.
Product can break, chip, or cause injury if handled carelessly.
NOTE: For drop-in and above-counter installation methods refer to
the "Drop-In and Above-Counter" section.
To install the drain, discard the gasket supplied with the drain.
Slide the foam gasket onto the drain body.
Insert the drain body into the sink drain hole.
Roll the O-ring onto the drain body.
Roll the O-ring up the drain body until it is seated in the
underside of the sink.
Align the sink and drain body assembly with the hole in the
countertop.
Lower the drain body through the countertop hole until the sink
rests on the countertop.
Slide the washer onto the drain body.
Thread the nut onto the drain body.
Tighten the nut until secure, making sure the drain is properly
centered in the sink.
Do not overtighten.
Apply a bead of silicone sealant (not provided), around the entire
countertop cutout so it is alongside the cutout hole.
Kohler Co.
Drain Body
Washer
Nut
9
Silicone
Sealant
1018897-2-B