Kobalt KJB 124B-03 Manual Del Usuario página 9

ASSEMBLY INSTRUCTIONS
3. To Install/Remove Battery Pack
To Attach Battery Pack
a. Make sure that the variable-speed trigger
switch (A) is in OFF position.
b. Align the raised portion on the battery pack
with the grooves on the bottom of the tool, then
slide the battery pack onto the tool as shown.
c. Ensure that the battery-release buttons on the
battery pack snap into place and the battery
pack is secured to the tool before beginning
operation.
NOTICE: When placing the battery pack on the tool,
be sure that the raised rib on the battery pack aligns
with the groove on the tool and the latches snap into
place properly. Improper assembly of the battery
pack can cause damage to internal components.
To Detach Battery Pack
a. Make sure that the variable-speed trigger switch (A) is in the OFF position.
b. Press the battery-release buttons to release the battery pack.
c. Pull backward on the battery pack to remove it from the tool.
WARNING
• Battery tools are always in operating condition. Therefore, the variable-speed trigger switch
should always in OFF position when the tool is not in use or when carrying the tool at your
side.
3
9
A
Battery-release button