Using Your Tv; Selecting The Tv Signal Source; Changing Channels; Selecting A Digital Sub-Channel - Insignia NS-LCD19 Guia Del Usuario

4 Press the INPUT button repeatedly to select
the VIDEO5 input source, then press PC to
toggle from HDMI to VGA.
TV
RS-232 (for service)
RS-232
AUDIO VGA
Audio cable

Using your TV

Turning your TV on and off
To turn your TV on and off:
1 Make sure that the power cord is connected
to your TV and a power outlet.
2 Press the button to turn on your TV. The
power indicator LED turns green.
3 Press the button again to return your TV
to standby. The power indicator LED turns
orange.

Selecting the TV signal source

To select the TV signal source:
• With the TV on, press the INPUT button on
either the TV or the remote to choose from:
ANT (antenna)
• Video1 (composite)
• Video2 (S-Video)
• Video3 (component)
• Video4 (VGA - computer)
• Video5 (HDMI)
If you select Video1, press the VIDEO button
to choose between composite and S-Video.
Note
HDMI, the HDMI logo and High-Definition
Multimedia Interface are trademarks or registered
trademarks of HDMI Licensing LLC.
Setting up the channel list
After you select your TV source, if you selected
antenna or cable you need to set up the channel
list. When you set up your channel list, your TV
searches for all available channels in your area
and stores a list of these channels. When you
press the CH – or CH + buttons, your TV skips
the channels that do not have a signal.
8
VGA cable
www.insignia-products.com
Insignia NS-LCD19 19" LCD TV
Automatically setting up channels
To automatically set up the channel list:
1 Press the MENU button. The Main on-screen
display menu opens with Setup highlighted.
2 Press the button to enter the sub-menu,
then or button to highlight Auto Ch
Search.
3 Press ENTER or
Note
You can press the Exit button to stop the search.
Manually adding or deleting channels from
the channel list
After you create a channel list using the Auto Ch
Search option, you can manually add or delete
channels from the channel list.
To add or delete channels:
1 Press the MENU button. The Main OSD
(On-Screen Display) menu opens with Setup
highlighted.
2 Press the button to enter the sub-menu,
then or to highlight Manual Channel
Set. The Channel Setup Table opens.
3 Press the or
then press then press ENTER to toggle
between viewable and not viewable.
4 Press MENU or EXIT to close the menu.

Changing channels

To change channels:
• Press the CH – or CH + button on the remote
control to go to the next lower or higher
channel.
- OR -
Press the number buttons to directly select a
channel (for example, if you want channel 83,
press 8, then press 3).
- OR -
Press the RECALL button to go to the last
viewed channel.

Selecting a digital sub-channel

Most digital TV channels have more than one
channel. The main channel carries the signal for
the main TV program. The sub-channels carry
signals for additional or alternate programming,
such as a radio or news broadcast.
ENTER
to start the search.
button to select a channel,