Axis NITRIS Manual De Instrucciones página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

All LEDs Lit: shaver is fully recharged
Fig. 1
LEDs Light Sequentially: shaver is operating
normally
When using the shaver for the first time or if the
shaver has not been used for a long time, charge
the shaver for 16 hours.
1. Insure that the On/Off switch is in the "Off" position. First, connect
the power cord to the shaver and then plug it into an electric outlet.
2. During recharging, the LEDs will flash and
then remain lit as the unit recharges. Recharging generally takes one
hour. When fully charged, the shaver will provide approximately one
week of shaving run time.
Storing the Shaver and Power cord
If the shaver is to remain unused for a long period of time, store the
unit and power cord in a cool, dry place. Do not wrap the cord around
Axis Nitris and Axis Fuel |20| english
LEDs Flash Sequentially and Then Lit - Shaver is Recharging
All LEDs Lit - Shaver is Fully Recharged
LEDs Light Sequentially - Shaver is Operating Normally
Fig. 2
the unit during storage. Avoid twisting the power cord. Be sure to
unplug and untwist the cord if it becomes twisted during use or while
charging.
Removing the Batteries for Disposal/ Recycling
It is important that the rechargeable batteries in the shaver be recycled
or properly disposed of after it has reached the end of its useful life.
Turn the On/Off Switch "on" and run the shaver until the inner cutters
stop.
1. Remove the headguard, foil screen assembly, and inner cutters.
2. Remove the 2 screws on the top of shaver. (Fig.
1)
3. Remove the 5 screw covers on the back of
shaver. Remove 2 side panels.
Axis Nitris and Axis Fuel |21| english
1
Fig. 1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

FuelAx-3335Ax-3331

Tabla de contenido