Axis NITRIS Manual De Instrucciones página 5

18. The hand-held unit shall be detached from the power supply cord
before cleaning.
19. The shaver shall not be used until it has dried.
SAVE THESE INSTRUCTIONS
PRECAUTIONS ON USING THE SHAVER
> Do not keep the shaver in a humid place, a place where the shaver
is exposed to splashes of water, or in high temperatures.
> To clean the body case of the shaver, wipe it with a cloth soaked
with a diluted water solution of a neutral detergent. Do not use thin-
ner or benzene as it will damage the plastic portions of the body.
> Do not recharge the shaver or use it with an AC power supply when
the room temperature is below 0° C or over 40° C. Also, never
recharge it under direct sunlight or near a heating element such as
heater or incandescent light.
Axis Nitris and Axis Fuel || english
> Do not recharge the shaver or use it with an AC power supply in a
humid place or a place where the shaver is exposed to splashes of
water.
> Do not leave the shaver unattended while it is recharged.
> If pre-shave lotion or shaver oil sticks to the body case of the
shaver, wipe it off completely. Otherwise, the plastic portions of the
shaver may be damaged.
> Before shaving, wipe off oiliness of your face. Otherwise, the shav-
ings will stick to the outer foil as the inner blade rubs against it. If
you find the outer foil soiled, wipe it clean with tissue paper or the
like before using the shaver.
> Excessive application of shaver oil will also soil the outer foil. In that
case, wipe the foil clean with tissue paper or the like before using
the shaver. When cleaning the shaver, take care not to apply an
excess amount of shaver oil on the inner blade and outer foil.
Axis Nitris and Axis Fuel || english