Important Instructions - Cadet SoftHEAT EBHN500-1 Manual Del Usuario

electric shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. A heater has hot and arcing or sparking parts
inside. Do not use it in areas where gasoline,
stored.
3. This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. If provided,
use handles when moving this heater. Keep
combustible materials, such as furniture, pillows,
bedding, papers, clothes, and curtains away from
heater.
Inside a SoftHEAT baseboard, an imperviously sealed heat
the solution is heated, warmth is generated and transmitted
(it could initially take 30 to 60 minutes to warm a room,
depending on the room size).
As the warmth spreads outward from the heater, cooler air
heater. "Convection air heating" (see Figure 1) means no
noisy fans are needed and the room is warmed with even,
comfortable heat. There will be no cold and hot spots in the
room as found with other types of heaters. SoftHEAT won't
blow or burn dust particles, making it recommended for
those with severe allergies.
A Cadet wall thermostat is recommended for optimum performance, or you may prefer the convenience of a
built-in EBKN thermostat kit. For instructions on wiring a thermostat, see the instructions that were included
with your thermostat. Refer to the section later in this guide titled "Step 3: Thermostat" prior to installing the
baseboard, or if you are installing a wall thermostat.
Wire connection is standard from the left end of the baseboard heater. Determine on which side of the base-
board you are making wire connections by locating the supply wires. Heaters may be purchased special or-
It is extremely important that you verify the electrical supply wires are the same voltage as the heater (i.e. 120
volt heater to 120 volt power supply and 240 volt heater to 240 volt power supply). If replacing an existing
heater check the labels of the old heater and replace using same voltage. Hooking a 240 volt heater to a 120
volt power supply will drastically reduce the heater's output. Hooking a 120 volt heater to a 240 volt power
supply will destroy the heater.
The SoftHEAT baseboard heater must be properly leveled when installed, in order for the heating chamber to
function properly.
www.cadetheat.com
Page 2

IMPORTANT INSTRUCTIONS

Before you begin, you should know
You must locate the supply wires before mounting the heater.
SAVE THESE INSTRUCTIONS
Tel: 360-693-2505
intakes or exhaust in any manner. Do not use on
soft surfaces, like a bed, where openings may
become blocked.
5. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening as this may
heater.
6. Save these instructions.
...
PO Box 1675 Vancouver, WA 98668-1675