Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
United States
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
flammable vapors and liquids in the vicinity of this or any other appliance.
1. Clearances and Dimensions
a. Provide adequate clearances between the range and adjacent combustible surfaces.
b. Location—Check location where the range will be installed. Check for proper electrical supply and the stability of floor.
c. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must
be solid and level.
FRONT
TYPICAL CABINET INSTALLATION
VIEW
* 30" minimum clearance between the top of the cooking surface
and the bottom of an unprotected wood or metal cabinet; or 24 "
minimum when bottom of wood or metal cabinet is protected by not
less than ¼" flame retardant millboard covered with not less than
no. 28 MSG sheet steel, 0.015" stainless steel, 0.024" aluminum
or 0.020" copper. The minimum clearance is 0" for the rear of the
range. Follow all dimension requirements provided above to prevent
property damage, potential fire hazard, and incorrect countertop
and cabinet cuts.
Avoid locating cabinet storage space above the surface units
to eliminate the possibility of cabinets catching on fire, or
personal burns from reaching for the cabinets over the heated
units. If cabinet storage is to be provided, risk can be reduced by
installing a range hood that projects horizontally a minimum of
5" beyond the bottom of the cabinets.
Important Notes to the Installer
1. Read all instructions contained in these installation instructions
before installing the appliance.
2. Remove all packing material before connecting the electrical
supply to the appliance.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
Important Note to the Consumer
Keep these instructions with your Use and Care Guide for future reference.
Printed in United States
FOR YOUR SAFETY: Do not store or use gasoline or other
1/8
FRONT
SIDE
VIEW
VIEW
1
All dimensions for
electrical outlet
location are maximum.
Cubed area shows
where the electrical
Terminal
outlet must be
Block
installed for the
Location
range to be flush to
the wall.
318201724 (0904) Rev. A
Canada
BACK
VIEW
Wall
Edge

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Frigidaire FGEF304DKF

  • Página 1 30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. United States Canada IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
  • Página 2 30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS The user is responsible for connecting the power supply cord 2. Install Anti-Tip Bracket (See instructions on to the connection block located behind the back panel access page 4.) cover. This appliance may be connected by means of permanent 3.
  • Página 3 30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS Three Conductor Wire Connection to Range Four Conductor Wire Connection to Range If local codes permit connection of the frame grounding Where local codes does NOT permit connection of the frame conductor to the neutral wire of the copper power supply cord grounding conductor to the neutral wire of the copper power (see Figure 3): supply cord (see Figure 4):...
  • Página 4: Direct Electrical Connection To The Circuit Breaker, Fuse Box Or Junction Box

    30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS Direct Electrical Connection to the Circuit Where local codes DO NOT permit connecting the appliance-grounding conductor to the neutral (white) Breaker, Fuse Box or Junction Box wire, or if connecting to 4-wire electrical system (see If the appliance is connected directly to the circuit breaker, Figure 6): fuse box or junction box, use flexible, armored or nonmetallic...
  • Página 5: Important Safety Warning

    30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS 5. Leveling the Range 6. Anti-Tip Bracket Installation Instructions IMPORTANT SAFETY WARNING A. Install an oven rack in the center of the oven. B. Place a level on the rack (see Figure 7). Take 2 To reduce the risk of tipping of the range, the range readings with the level placed diagonally in one must be secured to the floor by properly installed anti-...
  • Página 6 30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS NOTES...
  • Página 7: Para Su Seguridad

    INSTRUCCIONES PARA INSTALACION DE LA ESTUFA ELECTRICA DE 30” LA INSTALACIÓN Y EL SERVICIO DEBEN SER EFECTUADOS POR UN INSTALADOR CALIFICADO. Canadá Estados Unidos IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. PARA SU SEGURIDAD: No almanece ni utilice gasolina u otros vapores y líquidos inflamables en la proximidad de este o de cualquier otro artefacto.
  • Página 8: Placa De Identificación

    INSTRUCCIONES PARA INSTALACION DE LA ESTUFA ELECTRICA DE 30” 2. Instale los soportes antivuelco. El utilizador es responsable de la conexión del cable del (Ver suministro eléctrico al bloque de conexión situado detrás instrucciones en la página 4.) del panel de acceso. 3.
  • Página 9 INSTRUCCIONES PARA INSTALACION DE LA ESTUFA ELECTRICA DE 30” Conexión del cable de cuatro conductores a la cocina. Conexión del cable a tres alambres la cocina Si los códigos locales permiten la conexión del conductor a 1. Retire los tornillos de la parte baja de la cubierta del tierra del armazón al alambre neutral del cable de bronce del cable trasero (cubierta de acceso), para tener acceso suministro eléctrico (vea figura 3).
  • Página 10 INSTRUCCIONES PARA INSTALACION DE LA ESTUFA ELECTRICA DE 30” Conexión eléctrica directa al cortacircuito, a la caja de Donde los códigos locales NO permitan conectar el fusibles o la caja de empalmes conductor de puesta a tierra del electrodoméstico al Si el aparato está...
  • Página 11: Instrucciones Para La Instalación Del Soporte Antivuelco

    INSTRUCCIONES PARA INSTALACION DE LA ESTUFA ELECTRICA DE 30” 5. Cómo nivelar la estufa 6. Instrucciones para la Instalación del Soporte Antivuelco Coloque una parilla del horno en el centro del horno. B. Ponga un nivel sobre la parrilla (Figura 7). Tome dos ADVERTENCIA IMPORTANTE PARA SEGURIDAD lecturas con el nivel puesto diagonalmente en una Para reducir el riesgo de que la estufa se vuelque, ésta debe...
  • Página 12 INSTRUCCIONES PARA INSTALACION DE LA ESTUFA ELECTRICA DE 30” NOTAS...

Tabla de contenido