Rio RF-Polar Manual Del Usario página 12

INS TRU C TIO NS FOR US E
Place wand contacts on the skin and immediately
5
move the wand slowly in a small circular motion
in an area the size of your palm.
IMPORTANT: All four wand contacts must be
touching the skin for unit to have effect.
NOTE: As the skin warms up it will redden,
particularly on the Highest Heat Level.
After approximately 1-2 minutes (depending on
6
the heat level selected) all three CONSOLE lights
should begin to FLASH along with the WAND
light, indicating that you need to move to the next
adjacent area.
NOTE: If skin starts to feel uncomfortably hot
before the lights begin to flash remove the
wand and refer to troubleshooting section.
CAUTION SKIN OVERHEATING:
Indicated by RAPIDLY CIRCULATING
console lights and RAPIDLY FLASHING
wand light. Move to the next adjacent
area immediately.
Continue to work over your entire 'Treatment Zone'
7
using this method.
Once entire 'Treatment Zone' has been covered, a final
8
warming is required. Work over the entire area again in
large sweeping circles for approximately 2 minutes.
Treatment is now complete.
9
RF-Polar
™