Laminator Operating Modes; Hot Laminating; Positioning And Starting Up The Laminator - HP Pro Laminator 600 A4 Manual De Instrucciones

EN

Laminator Operating Modes

The laminator can process all cold and hot laminating pouches in the thicknesses 75 μ, 80 μ and
125 μ.

Hot Laminating

When "hot laminating" mode is active, the laminating pouch is heated to a temperature of approx.
130 °C to 160 °C as it passes through the laminator rollers. This creates a permanent thermal
bonding of the laminated material and the laminating pouch. Hot lamination permanently pre-
vents the laminated material from coming into contact with water, oxygen and bacteria.
Cold Laminating
When "cold laminating" mode is active, the laminating pouch is heated to a temperature of approx.
25 °C. The laminating pouches are coated with a special adhesive. The sides of the laminating
pouches are pressed together during the laminating process.
A detachable bond is produced and the material can be removed if necessary without any dam-
age.

Positioning and Starting Up the Laminator

The following section should help when starting up the laminator.
1 Set the laminator down on a level, stable working surface close to an easily accessible power
socket.
2 Switch the power switch (4) to OFF.
Only use the power cable supplied.
3
Connect the power cable to the connection socket (3) in the laminator.
4 Connect the power plug on the power cable to a power socket.
5 Switch the power switch (4) to ON.
Î The laminator confirms the action with an acoustic signal.
6 Press the button (9) to switch the laminator on.
Î The transport rollers start to rotate.
Î The button (7) lights up BLUE.
7 Fold out the pouch tray (1).
Î The laminator has been put into operation.
- 18 -