Operating The Laminator - HP Pro Laminator 600 A4 Manual De Instrucciones

EN

Operating the Laminator

The following section describes how to complete hot lamination and cold lamination.
If the laminator is not used for a period of 30 minutes, the laminator enters Standby mode.
The three operating mode buttons flash BLUE. Press one of the flashing buttons so that the
laminator is ready to operate again or press the
1 Select the operating mode required by pressing one of the following buttons:
button (5) for hot lamination, 75/80 micron.
75MIC
80MIC
button (6) for hot lamination, 125 micron.
125MIC
button (7) for cold lamination at 75/80 or 125 micron.
Î Hot laminating: The selected button flashes BLUE during the warm-up phase (approx. 1
minute) and lights up BLUE continually on reaching the operating temperature.
If the laminator was previously used in "Hot laminating" mode, the
The laminator must be allowed to cool down for approx. 30 minutes before it is ready to
operate.
Î Cold laminating: The selected button lights up BLUE
Î The laminator is ready for operation.
Caution!
Risk of burns through hot machine surface!
The laminator heats up during hot lamination. Do not touch the device surface during
operation.
2 Place the material to be laminated inside the laminating pouch. For the best results, leave a
space of 3 mm to 5 mm at the margin on all sides.
3 Insert the laminating pouch in the infeed (rear) of the laminator when ready to operate.
button (9) to switch the laminator off.
- 20 -
button (7) flashes BLUE.