Typical Installations - NuTone QTN130LE1 Instrucciones De Instalación

TYPICAL INSTALLATIONS

Housing mounted to joists.
Housing mounted to I-joists.
Use I-joist spacer block (provided).
Housing mounted to truss.
To mount housing anywhere between joists, i-joists or trusses, use
optional hanger bar kit QTHB1 (sold separately). Follow mounting
instructions included with kit.
PLAN THE INSTALLATION
COOKING AREA
Do not install above or
inside this area.
o
45
NOT FOR USE IN
A COOKING AREA.
INSULATION*
(Place around and
over Fan Housing.)
FAN
HOUSING
POWER
CABLE*
Seal gaps
around
Housing.
ROUND
DUCT*
Seal duct
joints with
ROUND
*Purchase
tape.
ELBOWS*
separately.
The unit will operate most quietly and efficiently when located
where the shortest possible duct run and minimum number of
elbows will be needed.
Use a roof cap or wall cap that has a built-in damper to reduce
backdrafts.
Plan to supply the unit with proper line voltage and appropriate
power cable.
MODEL QTN130LE1
Page 2
o
45
Cooking
Equipment
Floor
ROOF CAP*
(with built-in
Keep duct
runs short.
OR
WALL CAP*
(with built-in
damper)
damper)