Configuration; Programming; Reset - Bticino L4561N Instrucciones De Empleo

L4561N

3 CONFIGURATION

Before programming the Stereo Control (it must not be connected to the BUS):
S = 1 – 4
device address in the system
M1 =1 – 4 (indicate the number of Hi-Fi system modules, e.g. Radio, CD..., which the
Stereo Control must manage)
If the multi-channel matrix (item F441M) is used, only one Hi-Fi system module can be ma-
naged, so configure M1=1.
Connect the BUS cable and then the RCA-RCA cable and the IR jack.
3.1

PROGRAMMING

To program item L4561N use the TiStereoControl software supplied in the CD which comes with
the device, referring to its manual.
3.2

RESET

Restore the factory settings as follows:
- Switch the Stereo Control off
- Configure: S = – ; M1 = – ; M2 = 9
- Switch the device back on and wait for LED 3 to light up
- Switch off and restore the configuration
32