Speedaire 3HDR1 Guia De Inicio Rapido página 2

Speedaire Operating Instructions and Repair Parts Manual
Speedaire
Receivers without Top Plate
IMPORTANT: When isolators are used,
a flexible coupling should be installed
between tank and service piping.
Never use wooden
E
shipping skid(s) as
N
vibration isolators.
G
Never drill, weld,
or modify the
L
pressurized part of air tanks.
I
2. Do not weld or modify the
S
pressurized part of the tank. It
H
is allowable to drill holes in the
base-plate only for the purpose of
mounting the pump or guards.
Installation (Continued)
REMOvAL OF INSPECTION PLUG
Notes
ASME Code Air
®
To remove the ASME Inspection Plug, use
a wrench and turn counter-clockwise.
INSTALLATION OF ASME INSPECTION
PLUG
To install the ASME Inspection Plug, use
a wrench and torque (clockwise) the
plug from 42 ft. Ibs. minimum to 100 ft.
Ibs. maximum. Be sure the o-ring on the
ASME Inspection Plug is in place.
Failure to comply
with these guidelines
can result in personal injury and/or
property damage due to tank failure.
2
3HDR1, 3HDR2, 3HDR3 and 3HDR4
Operation
• These tanks are designed and
intended to be used as air
receivers only.
• Maximum pressure of tank should
not exceed 200 psi.
Maintenance
Failure to drain tank can result in
weakening due to rust and bursting.
Drain moisture
from tank daily.