Connect To Power - Vollrath Cayenne Manual Para Operadores

INSTALLATION
Install the Light Bulbs and Light Covers
Prior to installing the shelves and doors, install the lights and light
covers.
1. Remove the light covers and light bulbs from their packaging.
2. Slide one light bulb in the lower receptacle slot.
3. Slide the light bulb into the upper receptacle slot.
4. Rotate the light bulb until it snaps into place correctly, seating into
the receptacles.
2
5. Install the light cover into the bracket. Set the cover edge on the
inside of bracket edge. Starting at the bottom, press the light cover
edge on the inside of light bracket, continue to the top.
6. Repeat the steps to install the other light bulb and light cover.
Install the Shelves
1. Place the uprights into the provided slots making sure that the
longer tab is on top and the flat sides face inward.
2. Place the shelf supports at the desired locations and position the
shelf on these supports. The shelf supports and shelves can be
positioned level or sloping forward for improved presentation.
Install the Doors
The longer doors are for the customer/slopped side and the shorter
doors are for the operator/straight side.
1. Face door the handles toward the outside of the display case.
2. Place the top of each door into the top track and slide the door up to
clear, and then lower it into the bottom track.

Connect to Power

Plug the equipment into a properly grounded electrical supply that
matches the voltage rating on the nameplate.
NOTICE: Using a voltage other than the nameplate rated voltage will
cause damage to the unit. Incorrect voltage, modification
to the power cord or electrical components can damage
unit and will void the warranty.
®
Cayenne Heated Angled Display Cases Operator's Manual