Kohler STERLING 14700 Guia De Instalacion página 4

Sealant
Cut-Out
Apply a bead of sealant to the lip of the
sink and set it in the opening.
2. Install the Faucet Fitting
Install the faucet and drain fitting according to the manufacturer's
instructions. If you are reusing fittings from an old sink, use
plumbers putty under the faucet base and top flange of the
strainer.
Install the mounting clips on the sink edge in the locations shown
above.
3. Attach the Sink
WARNING: Risk of personal injury. Metal surfaces are sharp
and can cause severe cuts. Use gloves and handle the sink
edges carefully.
Apply a bead of silicone or latex sealant around the edge of the
sink.
Set the sink into the cut-out and position squarely.
Loosen the mounting clip nuts and move the metal legs into
position. Push each metal leg against the bottom of the
countertop. Tighten the nuts evenly, tightening the middle clips
first and then the corners until the rim is sealed.
CAUTION: Risk of property damage. Do not overtighten. It is
only necessary to draw the rim down firmly to the countertop.
Reposition fasteners as required to compensate for an uneven
countertop.
1014305-2-F
Loosen the leg nuts and slide the
metal leg tight to the countertop prior
to tightening the nuts.
Sink Edge
Countertop
Mounting Clip
Metal Leg
Back View Of
Mounting Clip
4
Nut
Sterling