Specifications; Assembly - Shindaiwa T272 Manual Del Propietário

Specifications T272X/C272
Engine Code ................................................................S7E Engine
Dry weight, T7
(less attachment) ...............................................6.7kg/14.7 pounds
Dry weight, T7X
(less attachment) ...............................................6.7kg/14.8 pounds
Type..........................................-cycle, vertical cylinder, air cooled
Bore x Stroke .................................34 mm x 30 mm/1.3 in. x 1. in.
Displacement ..........................................................7.cc/1.7 cu. in.
Maximum Power Output ............................................1.1 kw/1.4 hp
Operating rpm Range ..................................4,500-9,000 rpm (min
Transmission Type ............................Automatic centrifugal clutch
Fuel/Oil Ratio ...................................50:1 with ISO-L-EGD or JASO
Fuel Tank Capacity ............................................670ml/.6 ounces
Specifications are subject to change without notice.
This unit comes fully assembled with the
exception of the cutting attachment shield
and cutting attachment.
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete
unit and inspect unit and components for
any damage.
Assembly and Adjustments Handle T272/T272X
The handle is attached to the outer tube
on the T7/T7X.
To Adjust the Handle.
1. Loosen the 4 socket-head capscrews on
the handle. See Figure 5.
. Position the handle forward of the
Handle Positioning Label at the best
position for operator comfort (usually
about 10 inches ahead of the throttle
housing).
3. Secure the handle by alternately tight-
ening the four socket-head cap screws
in a diagonal or "criss-cross" fashion.
)
-1
through bevel gears
FC class -cycle mixing oil*
n Engine and shaft assembly
n Cutting attachment shield
n Cutting attachment
n Kit containing cutting attachment shield
bracket and hardware, this owner's/
opertor's manual and tool kit for routine
maintenance. Tool kits vary by model
and may include a hex wrench set,
spark plug/screwdriver combination
wrench and a spanner.
4 Socket-head Cap-
screws
Figure 5
Carburetion ..................................................Walbro diaphragm-type
Ignition..................................Fully electronic, transistor controlled
Spark Plug ................................................................Champion CJ8Y
Air Cleaner Type ...................................Non-reversible heavy-duty
Starting Method ......................................................................Recoil
Stopping Method ...............................Slide switch, grounding type
Handle ................................................................Loop handle (T7)
Loop handle with barrier bar (T7X)
EPA Emission Compliance Period**...........................Category A
* Shindaiwa One meets or exceeds these specifications and is recommended
for all Shindaiwa Products
** The EPA emission compliance referred to on the emission compliance label lo-
cated on the engine, indicates the number of operating hours for which the engine
has been shown to meet Federal emission requirements. Category C = 50 hours
(Moderate), B = 15 hours (Intermediate) and A = 300 hours (Extended).
The terms "left," "left-hand," and "LH":
"right," "right-hand," and "RH"; "front" and
"rear" refer to directions as viewed by the
operator during normal operation of this
product.
Handle
Handle Positioning Label
Outer Tube
Barrier
Bar
filter element
IMPORTANT!
T272X Shown
5