Shindaiwa T272 Manual Del Propietário página 8

Assembly and Adjustments Installing a Blade T272X
NOTE:
The T7X is shipped with Holder "A," the
safety clip, Holder "B," shaft bolt, and bolt
guard installed. The shaft bolt is a LEFT-
HAND THREAD AND IS REMOVED IN A
CLOCKWISE ROTATION!
1. With the gearcase output shaft facing
up, rotate the gearshaft and holder
"A" until the hole in holder "A" aligns
with the matching hole in the gearcase
flange, and then lock the holder to the
gearcase by inserting the long end of
the hex wrench through both holes.
See Figure 1.
. Remove the shaft bolt, bolt guard and
holder B. See Figure 1.
3. Slide the safety clip off center on the
gearcase shaft. See Figure 1-A.
4. Slide the blade over the safety clip and
onto the flange on Holder "A." See
Figure 1-B
5. Lock the blade on the shaft by center-
ing the safety clip. See Figure 1-C.
CAUTION!
Install the blade so its printed surface
is visible to the operator when the
brushcutter is in the normal
operating position.
WARNING!
The blade must fit flat against the
holder flange. The blade mounting
hole must be centered over the raised
boss on blade holder A.
NOTE:
When installing certain blades, it may be nec-
essary to temporarily remove the safety clip.
6. Install Holder "B" on the gearcase
shaft. See Figure 13.
IMPORTANT!
The machined recess in Holder "B" must
completely surround the safety clip, and
both holders must be flat against the
surface of the blade.
7. Lock holder "A" to the gearcase by in-
serting the long end of the hex wrench
through both holes as done in step 1
and tighten the shaft bolt securely with
the combination spark plug/screw-
driver wrench. See Figure 14.
8. Remove the hex wrench.
8
Shaft Bolt
Bolt Guard
Holder "B"
Safety Clip
Holder
"A"
B
Slip the blade in place
Figure 12
Blade
Figure 13
Tighten the assembly
Combination Spark
Plug/Screwdriver
Wrench
Holder "B"
Figure 14
WARNING!
Never operate the brushcutter without
the safety clip installed and both hold-
ers tightly secured and flat against the
blade surface!
A
Gearcase
Shaft
35010
Hex
Wrench Slide the safety clip off-center
C
35012
Hex Wrench
The T272X should now be completely as-
sembled to operate with a blade.
35011
Center the safety clip
35013
35014
Install Holder
"B"
Blade not shown
for clarity
35015
Bolt Guard