ratiotec CS 50 Instrucciones De Uso página 6

Coin counting and sorting machine CS 50
Introduction
Dear customer,
thank you for acquiring the coin coun-
ting and sorting machine coinsorter
CS 50. The purchase of this quality
product was an excellent decision.
General precautionary measures
Dirt and residue may cause counting
errors. If the coins are mixed with dirt
or residue, place them into a contai-
ner and clean them first before fee-
Please note: intense light irradiation may cause incorrect counts or error messages.
The functions
Coin flap
The coin flap is located within the coin feed and enables the faultless infeed of coins into the machine.
Display
The display shows the counting result and the number of coins in batch mode.
Switch on device
Use the switch on the rear of the machine to switch the machine on or off.
START / STOP key
This key is used for starting and stopping the counting process.
Report key
When the Report key is pressed, the respective quantities of the individual coins are displayed.
Set key
When the Set key is pressed, the preset number for counting stops is displayed.
+ / - keys
The number of counting stops can be increased or decreased by using the + or - keys.
Bat key
Progressive throughput of counting stops.
C key
Use the Clear key to reset the counter to zero for a new counting process. At the same time, this
serves to end the batch mode.
6
In order to ensure trouble-free operation, please read the in-
struction manual carefully.
ding them into the machine. A dirty sensor could also cause
a counting error.
Place the machine onto a level surface.