Flexible
Hose
Supply
Stop
5. Supply Connections
- If the lavatory is not installed, install it now. Be sure to follow all
instructions packed with the lavatory.
- Attach the flexible hoses to the supply stops. (Left is hot right is
cold.)
- Wrench tighten all connections.
6. Installation Checkout
- Connect the tailpiece and P trap.
- Ensure that all connections are tight.
- Remove aerator assembly by turning it counterclockwise.
- Open the drain.
- Turn on main water supply and check for leaks. Repair as needed.
- Lift faucet handle and run hot and cold water through the spout for
about a minute to remove debris. Check for leaks. Turn faucet off.
- Remove any debris from aerator and reinstall.
Kohler Co.
Aerator
9
Spout
B
1002277-2-